How To Apply A Small Sticker or Decal

 

Step 1

Clean the area thoroughly with rubbing alcohol or soap and water. Do not use Windex or similar products because it will leave a residue behind that will prevent the sticker from adhering well.

 

 

 

 

 

 

 

Step 2

Test Fit And Align Decal. Taking your time here is absolutely key. Be sure to measure and level the decal’s placement on the windshield or window. I used a few small bits of painter’s tape to mark its placement to make application easier.

 

 

Step 3

Remove The Decal Backing.Peel the decal’s paper backing away. Do this slowly. Peeling the paper backing off too quickly could pull portions of the vinyl off with it.

 

 

 

 

 

 

 

 

Step 4

Apply The Vinyl Decal To The Window Surface. Using consistent, firm pressure, run the straightedge over the decal several times. Use the straightedge to both press the vinyl to the surface of the window and push out any air bubbles stuck under the decal.

 

 

 

 

 

 

 

 

 

Step 5

Peel Off The Decal Cover. Slowly peel the clear transfer tape off at an angle. Be careful not to pull the sticker off the surface. If sticker pulls away from the surface repeat Step 4.add more firm pressure. ***Peel Vinyl Decal Cover Away. Peel back, not up.***

 

 

 

 

 

 

 

 

*Use a pin to poke any air bubbles in the center and push the air out through the hole.
*For best results do not apply a sticker in extreme hot or cold temperatures. Must be 55 or above. You can use a hair dryer to warm your window to apply the decal.